What do I do if the signal repeater is connected with FYRTUR or KADRILJ but nothing happens?
During initial installation, it may take a few minutes for the blinds to work after you connect the signal repeater.
After plugging in the signal repeater for the first time, it may take a couple of minutes for all devices to start communicating with each other. The system needs time to restore communication between the devices. This also applies in the event of a power failure or if the signal repeater is disconnected.
Did you find this useful?
Thank you for your feedback!
What particular parts of our articles do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
The blinds are easily controlled with the remote control and its various functions.
Read moreOur smart blinds can be controlled using both remote control and by voice control. By using the TRÅDFRI gateway or DIRIGERA hub, along with their respective apps.
Read moreIf you need to reset any of your smart products to their original settings (factory reset), you can easily follow the steps below for the product in question – or click through to our how-to videos to see how.
Read moreWith normal use (up and down once a day), the battery lasts for about four to six months before needing to be recharged.
Read moreYes you can! Should the battery run out, the blinds can still be used manually while the battery is charging.
Read moreCharging the battery for FYRTUR and KADRILJ takes four to five hours with charger from IKEA.
Read more